To Cancel; To Turn Off; To Resume; To Vary The Speed Setting - Fiat 500X 2020 Owner's Manual

To Cancel

The following conditions cancel the system:
The brake pedal is applied.

The CANC button is pushed.

An Anti-Lock Brake System (ABS) event occurs.

The gear selector is removed from the DRIVE

position.
The braking temperature exceeds normal

range (overheated).
The Electronic Stability Control/Traction

Control System (ESC/TCS) activates.
The vehicle parking brake is applied.

The driver switches ESC to Full Off mode.


To Turn Off

The system will turn off and clear the set speed
in memory if:
The Adaptive Cruise Control (ACC) on/off

button is pushed.
The Normal (Fixed Speed) Cruise Control on/off

button is pushed.
The ignition is placed in the OFF position.


To Resume

If there is a set speed in the memory, push the
RES button and then remove your foot from the
accelerator pedal. The instrument cluster
display will show the last set speed.
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming
a set speed that is too high or too low for
prevailing traffic and road conditions could
cause the vehicle to accelerate or decelerate
too sharply for safe operation. Failure to
follow these warnings can result in a
collision and death or serious personal
injury.

To Vary The Speed Setting

To Increase Speed
While ACC is set, you can increase the set speed
by pushing the SET (+) button.
The driver's preferred units can be selected
through the instrument panel settings (if
equipped). Refer to "Getting To Know Your Instru-
STARTING AND OPERATING
ment Panel" for more information. The speed
increment shown is dependent on the chosen
speed unit of U.S. (mph) or Metric (km/h):
U.S. Speed (mph)
Pushing the SET (+) button once will result in a

1 mph increase in set speed. Each subsequent
tap of the button results in an increase of
1 mph.
If the button is continually pushed, the set

speed will continue to increase in 5 mph incre-
ments until the button is released. The
increase in set speed is reflected in the instru-
ment cluster display.
Metric Speed (km/h)
Pushing the SET (+) button once will result in a

1 km/h increase in set speed. Each subse-
quent tap of the button results in an increase of
1 km/h.
If the button is continually pushed, the set

speed will continue to increase in 5 km/h
increments until the button is released. The
increase in set speed is reflected in the instru-
ment cluster display.
163
5