Advertisement
Remote Control Fan Speed And Light Functions.
Fan speed
1 = minimum speed
3 = medium low speed
5 = medium high speed
This button turns the fan off.
Forward / Reverse button- This button controls the direction of the fan rotation .
Press once to change direction of the fan rotation. Fan must be running to reverse.
(Note: It can take a few seconds to change direction once button has been pushed.)
Light button- Press this button to turn light on or off. To dim light ( Setting at "DIM"
position ), hold down the button, the light will cycle from bright to dim to bright until button
is released.
Note : This remote control has an auto resume function, the fan and light will maintain the
last setting if power is turned off.
WALL MOUNT CRADLE INSTALLATION
Install Transmitter wall mount cradle with 2 screws provided.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS. (1)THIS DEVICE MAY NOT
CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
NOTE:
1. When powering on after installation, the fan may start automatically due to factory preset settings.
2. If fan or light isn't working, reset power ( turn the power off for at least 10 seconds and then turn the power back on )
and redo the learn function setting.
3. If there are multiple fans in the same room, when setting, please make sure the power supply for the setting fan is
independant of the other fans.
4. When turning the fan on or operating the forward/reverse function, it is normal for the fan to rotate and run on both
directions, for approximately 1 minute and then stop.
2 = low speed
4 = medium speed
6 = high speed
TN15122801
Advertisement
