Installation - Car-O-Liner CR35 Instruction Manual

This machine complies with the 89/392/CEE directives and subsequent modifications and
supplements.

INSTALLATION

PRECAUTIONS AND CHECKS
CAUTION: During all installation and connection operations, the machine must be
absolutely isolated from the power supply line.
CAUTION: Installation must be made by qualified personnel in compliance with the
applicable regulations and in accordance with the instructions of the manufacturer.
CAUTION: Before connecting the machine to the mains supply, make sure that the data
on the nameplate of the spot welder correspond to the voltage and frequency of the mains
supply available on site.
Electrical safety of the spot welder is obtained only when connected to an efficient
grounding system made in compliance with the applicable Regulations.
Have qualified personnel check the system for functional efficiency.
The Manufacturer cannot be held liable for possible damage caused by absence or
inefficiency of the grounding system.
Check that the installed power on the electric supply meter as well as the cables of the
electrical plant are adequate for the rated power of the spot welder.
CAUTION: In case the user makes modifications, alterations or changes of the spot
welder or integrates it in a plant, any liability of the Manufacturer decays and the user is
obliged to remove the CE label.
The non-observance of the above instructions will render the safety system provided by
the Manufacturer ineffective, causing serious risks of personal injuries and material
damage.
CAR-O-LINER p. 09
MOVABLE SPOT WELDER