Table of Contents
Advertisement
If all 99 storage locations already have data saved, the system automatically
overwrites the data stored in location 01 and continues to increase the storage
location number.
Recall Historical Data
During measurement, to recall the historical data:
1. Push and hold
2. Release
when
3. Use the up arrow key
you want to view to see the corresponding historical data.
4. To exit the Recall mode, push and hold
the environmental measurement screen.
In the Recall screen, you can also use
temperature saved at the current storage location, as well as, use
minimum, maximum and average temperature values saved.
Figure 7. Save Measurement Data
for at least 2 seconds.
flashes in the upper right corner of the screen, as shown in
and/or down arrow key
Figure 8.
Recall Historical Data
Increase by 1
Note
to select the storage location
Flashing
Storage
location number
for at least 2 seconds and the screen will return to
Note
to view the wet bulb/dew point
Temperature Humidity Meter
Use the Meter
Figure 8.
to view the
11
Advertisement
Table of Contents
