Light Tower Set Up - Generac Power Systems Magnum MLT4200 Operating Manual

LIGHT TOWER SET UP

1. For maximum light coverage, locate the unit at ground level or in a spot higher than the area being illuminated
by the lamps.
The mast extends up to 30 ft (9.14 m). Make sure area above the unit is open and clear
of overhead wires and obstructions. Do not set up the unit if high winds or storms
E
D
B
C
D
2. Place the unit on firm ground that is relatively flat, then block the wheels to keep it from moving (A). This will
make it easier to level the unit.
3. Pull the locking pin on the tongue jack and rotate the jack 90°. Replace the locking pin (B). Turn the jack handle
clockwise to raise the trailer tongue off of the towing vehicle.
4. Connect a good earthen ground to the grounding stud on the frame of the trailer at the base of the mast post (C).
Note: Refer to local codes for proper grounding requirements.
5. Pull the locking pin (D) on the outrigger (E) and pull each outrigger out until the spring loaded locking pin snaps
back into place. Pull the locking pin on the outrigger jack and rotate each jack 90° so the jack pad is facing down.
Replace the locking pin.
6. Pull the locking pin on the rear jack (F) and rotate the jack 90°. Replace the locking pin. Turn the jack handle
clockwise to start leveling the trailer. Adjust all four jacks by turning their handles clockwise (G) until they are
firmly in contact with the ground and the trailer is as level as possible.
14
WARNING
capable of producing lightning are expected in the area
H
A
E G
J
H
F
DETAIL C
DETAIL D
DETAIL G
DETAIL H
00152