Table of Contents
Advertisement
38
en | Maintenance
8.1.2
Removing a drive
When removing a drive from a 60-bay controller unit or a 60-bay expansion unit, you must lift
the drive partly out of the drawer and wait for the drive to spin down. Then, you can remove
the drive completely.
Before you begin:
–
–
To remove a drive:
1.
2.
3.
2021.05 | V3 | DOC
an attention icon on the drive handle just behind the LED.
1
1 = Attention LED on drive drawer
–
Unlatch the drive drawer by pulling on both levers.
–
Using the extended levers, carefully pull the drive drawer out until it stops.
–
Look at the top of the drive drawer to find the Attention LED in front of each drive.
1 = Attention LED light on for the drive on the top right side.
You have an ESD wristband, or you have taken other antistatic precautions.
You have reviewed the Rules for handling drives, page 36 .
Unpack the replacement drive, and set it on a flat, static-free surface near the unit. Save
all packing materials for the next time you need to send a drive back.
If you have not already done so, release the drive drawer levers from the center of the
appropriate drive drawer by pulling both towards the sides of the drawer.
If you have not already done so, carefully pull on the extended drive drawer levers to pull
out the drive drawer to its full extension without removing it from the enclosure.
Installation manual
DSA E-Series (E2800 60-bay)
1
Bosch Security Systems B.V.
Advertisement
Table of Contents
