Table of Contents
Advertisement
DSA E-Series (E2800 60-bay)
4.
5.
6.
7.
8.
9.
Notice!
i
If you accidentally remove an active drive, wait at least 30 seconds, and then reinstall it. For
the recovery procedure, refer to the storage management software.
8.1.3
Installing a drive
Install the replacement drive as soon as possible after removing the failed drive. Otherwise,
there is a risk that the equipment might overheat.
To install a drive:
1.
Bosch Security Systems B.V.
Gently pull back the orange release latch that is in front of the drive you want to remove.
The cam handle on the drive springs open partially, and the drive is released from the
drawer.
1 = Orange release latch
Open the cam handle, and lift out the drive slightly.
Wait 30 seconds.
Use the cam handle to lift the drive from the unit.
Place the drive on an antistatic, cushioned surface away from magnetic fields.
Wait 30 seconds for the software to recognize that the drive has been removed.
Raise the cam handle on the new drive to vertical.
Installation manual
Maintenance | en
1
2021.05 | V3 | DOC
39
Advertisement
Table of Contents
