Connection; Connecting The Expansion Units; Connecting The Controller Unit To The Network - Bosch E2800 Installation Manual

28 en | Connection
5

Connection

5.1

Connecting the expansion units

The expansion units are shipped with the appropriate number of SAS cables.
To connect the components:
4
One expansion unit - dual controller configuration
Two expansion units - two controller configuration
Notice!
i
You can connect a 60-bay DSA E2800 controller unit to a maximum of two 60-bay DSA E2800
expansion units.
5.2

Connecting the controller unit to the network

In case of a Bosch Video Recording Solution a host is an IP camera. To connect the controller
unit to the Ethernet one or two of two available iSCSI host ports must be connected to the
Ethernet. The iSCSI port connections will then be used by the IP cameras for video data
traffic.
To connect the controller unit to the network:
4
2021.05 | V3 | DOC
Connect the SAS cable from the SAS port on the controller unit to the SAS port on the
expansion unit.
Controller
A
B
IOM
A
B
Controller
A
B
IOM
A
B
IOM
A
B
Connect the cable from the iSCSI host port of the controller unit to a port on the switch.
Note: Make sure that the iSCSI ports of the controller unit and the relevant IP camera
ports are in the same range on the switch.
Installation manual
DSA E-Series (E2800 60-bay)
Bosch Security Systems B.V.