Download  Print this page

Removing And Installing Memory; Memory Module Specifications; Populating Memory Modules - HP EliteOne 1000 G1 Hardware Reference Manual

All-in-one business pcs
Hide thumbs

Advertisement

Removing and installing memory

The memory slots on the system board can be populated with up to two industry-standard small outline dual
inline memory modules (SODIMMs). These memory slots are populated with at least one preinstalled memory
module.

Memory module specifications

For proper system operation, the memory modules must meet the following qualifications:
Component
Memory modules
Compliance
Pins
Support
Slots
Maximum Memory
Supported
Note
HP offers upgrade memory for this computer and advises that the consumer purchase it to avoid
compatibility issues with unsupported third-party memory.

Populating memory modules

Refer to the following table to identify the memory module channel locations.
Location
Lower Socket
Upper Socket
The system will automatically operate in single channel mode, dual channel mode, or flex mode, depending
on how the memory modules are installed.
The system will operate in single channel mode if the memory module slots are populated in one
channel only.
The system will operate in a higher-performing dual channel mode if the memory capacity of the
memory module in Channel A is equal to the memory capacity of the memory module in Channel B.
The system will operate in flex mode if the memory capacity of the memory module in Channel A is not
equal to the memory capacity of the memory module in Channel B. In flex mode, the channel populated
with the least amount of memory describes the total amount of memory assigned to dual channel and
Specification
1.2 volt DDR4-SDRAM memory modules
Unbuffered non-ECC DDR4-2400 MHZ–compliant
Industry-standard 260 pins containing the mandatory Joint Electronic Device
Engineering Council (JEDEC) specification
Support CAS latency DDR4 2400 MHz (15–15–15 timing)
2
16 GB per memory slot, 32 GB total
4 Gbit and 8 Gbit non-ECC memory technologies single-sided and double-sided SODIMMs
The system will not operate properly if you install unsupported SODIMM
memory. SODIMMs constructed with x8 and x16 DDR devices are supported; memory
modules constructed with x4 SDRAM are not supported.
System board label
SODIMM1
SODIMM3
Channel
Channel B
Channel A
Removing and installing memory
17

Advertisement

loading

This manual is also suitable for:

Eliteone 1000 g2