Locating Internal Components; Removing And Installing Memory; Memory Module Specifications - HP ProOne 600 G3 21 inch All-in-One Business PC Hardware Reference Manual

Locating internal components

Component
1
2

Removing and installing memory

The memory slots on the system board can be populated with up to two industry-standard small outline dual
inline memory modules (SODIMMs). These memory slots are populated with at least one preinstalled memory
module. A metal shield protects the memory modules.

Memory module specifications

For proper system operation, the memory modules must meet the following qualifications:
Component
Memory modules
Compliance
Pins
Support
Slots
Maximum Memory
Supported
Note
30 Chapter 3 Hardware repair and upgrade
Optical disc drive
Hard drive
Specification
1.2 volt DDR4-SDRAM memory modules
Unbuffered non-ECC PC4-17000 DDR4-2400 MHz-compliant
Industry-standard 260 pins containing the mandatory Joint Electronic Device
Engineering Council (JEDEC) specification
Support CAS latency 15 DDR4 2400 MHz (15-15-15 timing)
2
16 GB per memory slot, 32 GB total
1 Gbit, 2 Gbit, and 4 Gbit non-ECC memory technologies single-sided and double-sided
SODIMMs
The system will not operate properly if you install unsupported SODIMM
memory. SODIMMs constructed with x8 and x16 DDR devices are supported; memory
modules constructed with x4 SDRAM are not supported.
Component
3 Battery
4 Memory modules