Optane Memory Module - HP 200 G3 Maintenance And Service Manual

Optane memory module

IMPORTANT:
Both the Optane memory module and the solid-state drive cannot be installed at the same time.
1. Prepare the computer for disassembly (see
2. Remove the stand assembly (see
3. Remove the display (see
4. Remove the two Phillips screws that secure the M.2 module bracket to the system board (1).
5. Remove the bracket from the computer (2).
6. Remove the Phillips screw (1), and then pull the Optane memory module away from the connector (2).
Reverse this procedure to install the Optane memory module.
The Optane memory module installs into the same M.2 connector as the solid-state drive.
Stand assembly on page
Display on page
Preparation for disassembly on page
15).
16).
14).
Optane memory module 23