Locating Internal Components; Removing And Installing Memory; Memory Module Specifications - HP ProOne 600 Hardware Reference Manual

Locating internal components

Table 3-1 Internal components
Internal components
(1)
(2)

Removing and installing memory

The memory slots on the system board can be populated with up to two industry-standard small outline dual
inline memory modules (SODIMMs). These memory slots are populated with at least one preinstalled memory
module. A metal shield protects the memory modules.

Memory module specifications

For proper system operation, the memory modules must meet the following qualifications:
Table 3-2 Memory specifications
Component
Memory modules
Compliance
Pins
Support
Slots
Maximum memory
Supported
Note
24 Chapter 3 Hardware repair and upgrade
Optical disc drive (optional)
Memory modules
Specification
1.2 volt DDR4-SDRAM memory modules
Unbuffered non-ECC DDR4-2666 MHz SODIMM compliant
Industry-standard 260 pins containing the mandatory Joint Electronic Device
Engineering Council (JEDEC) specification
Support CAS latency 19 DDR4 2666 MHz (19-19-19 timing)
2
16 GB per memory slot, 32 GB total
8 Gbit (base) non-ECC memory technologies single-sided and double-sided SODIMMs
The system will not operate properly if you install unsupported SODIMM memory.
SODIMMs constructed with ×8 and ×16 DDR devices are supported; memory modules
constructed with ×4 SDRAM are not supported.
(3) RTC battery
(4) Hard drive