Use - Feider Machines FPO350 Original Instructions Manual

4. USE

INTENDED USE
- The sander is intended for dry sanding of wood, metal, plastic, plaster and painted surfaces. The sander
is not suitable for commercial use.
- The device is designed for use by adults. Adolescents over the age of 16 may use the device only under
supervision. The manufacturer is not liable for damages caused by unspecified use or incorrect
operation.
- Any other use or modification that is not explicitly approved in these instructions may result in damage
to the device and represent a serious danger to the user.
INSTALLING AND REMOVING THE DUST CANISTER
Before plugging in the tool, always make sure the switch trigger actuates properly and
WARNING,
returns to the OFF position.
The dust canister (3 ) allows the dust collection from the workplace. Place the canister on the dust exit
nozzle using steady force until it locks in place (fig 1). To remove the dust canister, follow the procedure in
reversed order.
NOTE: For maximum efficiency, the dust canister should be emptied frequently during operation.
NOTE: The collection of the dust will only work if the sandpaper has holes that line up with the 8 dust
collection holes in the Backing Pad.
INSTALLING AND REMOVING SANDING PAPER
Line up and then firmly press the round sanding paper (6) onto the round velcro sanding base (5) (fig 2). To
remove the sanding paper, just peel the disc away from the sanding base.
WARNING, Push firmy the sanding disc onto the sanding base so it can be evenly positioned, with the
velcro locking system.
NOTE: A bad placement of the sanding base that is not properly aligned will reduce sanding performance.
USING THE TOOL
1) Switching ON and OFF
To turn on the machine press the O/ I (ON / OFF) switch (1), so it reaches position " I " (fig 3). To turn the
machine off, press O/ I (ON / OFF) switch (1) so it reaches position "O".