Saving The Configuration; Selecting The Power-Up Configuration - Printronix SL5000E Quick Setup Manual

Saving The Configuration

SMT: Select Tool
This menu appears only if an RFID encoder is installed. See
"Software Migration Tools (SMT)" in the RFID Labeling Reference
Manual .
•
EPC, GTIN, UPCA, EAN8, EAN13, and UCC128. SMTs
displayed if Toolset [1] is selected under SMT: Sel Toolset.
•
zEPC, zGTIN, zUPCA, zEAN8, zEAN13, and zUCC128. SMTs
displayed if Toolset [2] is selected under SMT: Sel Toolset.
NOTE: Undocumented options are reserved for internal use and
Saving The Configuration
After customizing your settings, save them as a configuration:
1. Press the
2. Press ↑ or ↓ until Save Config. / 1* displays.
3. If necessary, press + or – until the desired configuration
displays.
4. Press
NOTE: You can specify a 15-character name for your configuration.
5. If necessary, set your newly saved configuration as the
Power-Up configuration. See "Selecting The Power-Up
Configuration" below.

Selecting The Power-Up Configuration

To have a saved configuration automatically loaded when you
power up the printer, set the saved configuration as the Power-Up
configuration:
1. Press the
2. Press ↑ or ↓ until Power-Up Config. / Factory* displays.
48
future design.
. .
key to enter the QUICK SETUP menu.
.
↵
. Saving Configuration displays briefly.
See "Name Config (1-8)" in the User's Manual .
. .
key to enter the QUICK SETUP menu.
.