Configuring The Printer - Printronix SL5000E Quick Setup Manual

Configuring The Printer

To avoid this problem, increase the Threshold Range value to 60%
in the CALIBRATE CTRL menu (the default is 50%), then run an
Auto Calibrate again (page 30).
NOTE: Any changes to Threshold Range will not take effect until
This will raise the Gap/Mark threshold high enough so that the
printer will not falsely use the antenna or noise as the gap (top-of-
form).
255
191
127
Paper Out(075)
063
Gap/Mark(040)
000
Configuring The Printer
The printer menu structure consists of main menus and menu
items, and the options available for each menu item. Modifications
to the menu items can be selected and saved using the control
panel. See "Control Panel" on page 14 for information about control
panel keys and navigating the menus.
When you press the
displays first. This menu lists the most frequently accessed menu
options.
36
you run an Auto Calibrate again.
Detected Amplitude
of the Antenna
. .
(Menu) key, the QUICK SETUP menu
.
Detected Amplitude
of the Gap