Table of Contents
Advertisement
Chapter 2
Powering On The Printer
Powering On The Printer
1
1. Plug the printer into a 200, 220, or 240 VAC, 30 Amp, 50-60 Hz
power source as shown on the rear panel label. (The DC power
supply must be set for the proper line voltage. Using an
incorrect power source or improperly setting the DC power
supply will damage the printer.)
2. Turn on the printer by setting the power switch to | (on).
3. Note that when you power on the printer, the following occur:
a. The printer reads the emulation and displays the message:
b. The ONLINE indicator lights continuously and STAND BY
40
Legend:
1)
Power Switch
"B0: Printer Boot
Please Wait..."
goes out.
Advertisement
Table of Contents
