Ptx Setup Option; Display Language - Printronix L1524 Setup Manual

Subsequent printing observes the current setting for skip-over perforation, form
length, and top-of-form position parameters.
Cancel the hex dump mode (while off-line), by disabling it from the control panel.
The paper then may be advanced to the next top-of-form.
If a fault occurs while printing a hex dump, the printer reverts to the normal fault
state. When the fault is cleared, the printer resumes printing the hex dump (either
a partial line with a form feed, or nothing at all). Top-of-form remains unaffected.
The Impact Print
er Emulation pri
nts in one–up, t
wo–up, and four–
up page windows,

PTX Setup Option

Values: Setup Parse and Setup SFCC
This option provides the ability to enable or disable the setup parse and to select
the Special Function Control Code (SFCC).
Setup Parse controls the use of PTX setup commands from the host computer.
With the option enabled, PTX setup commands are used. With the option
disabled, PTX setup commands are not used (this is the default).
Setup SFCC allows you to choose the special function control code to be used
with your application. Any single hexadecimal control code between hex 01 and
FF can be selected.

Display Language

Values: English (default), French, German, Italian, Spanish, and Dutch
This option is used to select the language for the control panel display. This
selection will change the display of all information on the LCD.
Configuring the Printer
54 68 65 20 49
65 72 20 45 6D
6E 74 73 20 69
77 6F 2D 75 70
75 70 20 70 61
Figure 3–13. Example of Hex Dump
6D 70 61 63 74
75 6C 61 74 69
6E 20 6F 6E 65
2C 20 61 6E 64
67 65 20 77 69
20 50 72 69 6E
6F 6E 20 70 72
2D 75 70 2C 20
20 66 6F 75 72
6E 64 6F 77 73
3–45
74
69
74
2D
2C