Printronix L1524 Setup Manual page 101

ERROR: NVRAM
FAILURE
ERROR: PROGRAM
NEEDS MORE DRAM
ERROR: PROGRAM
NEEDS MORE FLASH
ERROR: PROGRAM NOT
COMPATIBLE
ERROR: PROGRAM NOT
VALID
ERROR: SECURITY PAL
NOT DETECTED
ERROR: SHORT AT
ADDRESS xxxx
ERROR: WRITING TO
FLASH
ERROR: WRONG
CHECKSUM
Configuring the Printer
The non-volatile memory has
failed.
The printer requires more DC
DRAM memory in order to run
the downloaded program, or in
order to use the downloaded
files.
The printer requires more DC
flash memory in order to run the
downloaded program, or in
order to use the downloaded
files.
The downloaded program is not
compatible with the printer.
The printer did not detect an
emulation program in DC flash
memory, or the emulation
program in DC flash memory is
present but corrupted.
The security PAL is not present
or has failed.
Hardware failure in DC DRAM
or in controller board circuitry.
Hardware or software fault in
DC flash memory.
The printer received the
complete program or data file,
but the checksum did not match.
The data were corrupted during
download.
Contact service provider.
(Do NOT attempt to
replace NVRAM.)
Use a smaller emulation
program or have your
service provider add DC
DRAM to the controller
board.
Optimize the flash file
system. (See page
3–46.) If the message
persists, use a smaller
emulation program, or
have your service
provider add DC flash
memory to the controller
board.
Use the correct
emulation software
option(s) for this printer
model.
Power off the printer and
download the program. If
the message persists,
contact service provider.
Contact service provider
Contact service provider.
Power off the printer and
download the program
again. If the message
persists, contact service
provider.
Power off the printer and
download the program
again.
3–61