Factory Settings
Table 3–1 lists the the factory default settings (i.e., Config. 0). These values are
available for loading at any time, and are maintained in the printer until a new
configuration is loaded.
Mode
LinePrinter+
PCL5 (optional)
IGP/PGL (optional)
IGP/VGL (optional)
IPDS (optional)
CTHI (optional)
Host Interface
Centronics
Data Bit 8
PI Ignored
Data Polarity
Resp. Polarity
Busy On Strobe
Latch Data On
Prime Signal
TOF Action
Buffer Size In K
Dataproducts
Data Bit 8
P I Ignored
Data Polarity
Resp. Polarity
Latch Data On
Prime Signal
TOF Action
Buffer Size In K
3–12
Table 3–1. Factory Settings
LP+
(Refer to the LP+ User's
Manual for defaults.)
Enable
Enable
Standard
Standard
Enable
Leading
Enable
Reset
64
Enable
Enable
Standard
Standard
Middle
Disable
Reset
64
Configuring the Printer