Show Mode; Sound Activation - Martin RUSH MH-2 Wash User Manual

the MENU button again.

Show mode

Show mode provides four preprogrammed shows. These can be accessed
from certain DMX modes or the show will run if the fixture is not connected to
DMX or blacked out in a standalone fashion. Show mode can be combined
with sound activation.
To set a fixture's show mode:
1. Select SHOW MODE and press the ENTER button to confirm. The
present mode will blink on the display.
2. Use the DOWN and UP buttons to select Show 1, Show 2, Show 3 or
Show 4.
3. Once the mode has been selected, press the ENTER button to set (or, to
return to the higher level of the menu structure without any change press
the MENU button).

Sound activation

The fixture has a built-in microphone that can be used to synchronize its
behavior to the beat of music. When the fixture is not connected to a DMX
controller, and is running in Show Mode, it can be set to trigger scene changes
(effects, color changes and movement) in synch with music.
To turn on sound activation:
1. Select SOUND STATE and press the ENTER button to confirm. The
present mode will blink on the display.
2. Use the DOWN and UP buttons to select ON (sound activation on) or OFF
(sound activation off).
3. Once the mode has been selected, press the ENTER button to set it (or, to
return to the higher level of the menu structure without any change press
the MENU button).
To adjust the sensitivity of the sound-activation microphone:
1. Select SOUND SENSE and press the ENTER button to confirm. The
present mode will blink on the display.
2. Use the DOWN and UP buttons to change the sound sense from 0 ...100.
3. Once the level has been selected, press the ENTER button to set it (or, to
return to the higher level of the menu structure without any change press
the MENU button).
RUSH MH-2 Wash user manual 17