Using A Cross-Over Hub Cable And A Laptop To Connect To The Mcu Locally - Polycom MGC+100 Getting Started Manual
Polycom mgc+100 network: user guide
Hide thumbs
Also See for MGC+100:
- Release note (94 pages) ,
- Overview (12 pages) ,
- Installation & configuration manual (4 pages)
Table of Contents
Advertisement
Using a Cross-over Hub Cable and a Laptop to Connect to the MCU
Locally
1.
Connect a cross-over hub cable between the laptop LAN connection to
the LAN connection of the control unit on the rear panel of the MCU.
2.
On the laptop, click Control Panel ->Network Connection->Local
Area Connection.
3.
In the Local Area Connection - General dialog box
Properties
button
4.
In the Local Area Connection Properties dialog box, click Use the
following IP address, and define the address of the laptop as part of the
same network segment as the MCU. For example, 129.254.4.7.
5.
Click OK.
6.
Install the MGC+ Manager application and start this application.
7.
Define a new MCU using the default IP address:
a.
In the Browser pane, right-click the MCUs Network icon, and then
click New MCU.
The Add MCU dialog box opens.
b.
In the Name box, enter the name of the MCU. Specify a name that
clearly identifies the MCU.
MGC+50/MGC+100 Getting Started Guide
.
,
click the
2-21
Advertisement
Table of Contents
