Clear Fault Code; Read Data Stream; Resetting - Launch Creader 7001S Instructions Manual

Creader 7001S/8001S English User's Manual
LAUNCH

5.2.3 Clear Fault Code

After reading the retrieved codes from the vehicle and certain repairs have been
carried out, you can use this function to erase the codes from the vehicle. Before
performing this function, please be sure the vehicle's ignition key is in the ON
position with the engine off.

5.2.4 Read Data Stream

This option retrieves and displays live data and parameters from the vehicle's ECU.

5.3 Resetting

There are two methods to reset service lamp: Manual reset or Auto reset. Auto
reset follows the principle of sending command from the tool to vehicle's ECU to
do resetting. While using manual reset, users just follow the on-screen
instructions to select appropriate execution options, enter correct data or values,
and perform necessary actions, the system will guide you through the complete
performance for various service operations.
For Creader 7001S, just follow the flowchart below to perform resetting.
Figure 5-5 (For Creader 7001S)
For Creader 8001S, the resetting function is loaded with each single vehicle
model and can be done in process of the System Scanning operation. Refer to the
following illustration to proceed.
17