Table of Contents
Advertisement
LAUNCH
7. The Register Code shown in figure 7-5 is the Register Code needed in step 3.
(Return to step 3 and input the Register Code and then proceed)
8. Install the memory card from the tool into the supplied memory card adaptor
and insert into the USB port of the computer.
9. Reopen the update tool, select the updates you would like to perform or click
"Select All", and then click [Download] to start downloading.
10. Once all steps are complete, reinsert the memory card into the tool and power
the tool via USB cable or via OBD II cable. A dialog box (Note: If only
diagnostic software is updated and no firmware package is downloaded, this
box will not appear) prompting you to update will pop up on the screen (See
figure 7-6), select [OK].
11. The registration process is completed, your tool is now ready for use.
Creader 7001S/8001S English User's Manual
Figure 7-5
Figure 7-6
26
Advertisement
Table of Contents
