Table of Contents
Advertisement
IMPORTANT:
Always disconnect the appliance from the gas
and electricity mains before carrying out any
cleaning operation.
2) GAS HOB
Periodically wash the hob, pan stands, enamelled
burner covers "C", and burner heads "T" (see fig.
6) must also be washed and the ignition elements
"AC" and safety cut-off sensors "TC" (see fig. 6)
must be cleaned.
dishwasher. Following this, all parts should be
thoroughly rinsed and dried. Never wash them
while they are still warm and never use abrasive
powders. Do not allow vinegar, coffee, milk, salted
water, lemon or tomato juice to remain in contact
with the enamelled surfaces for long periods of
time.
CLEANING
Do not wash them in the
Note: continuous use could cause the
burners to change colour due to the high
temperature.
WARNINGS:
Comply with the following instructions, before
remounting the parts:
- Check that burner head slots "T" (fig. 6) have
not become clogged by foreign bodies.
- Check that enamelled burner cap "C"(fig. 6)
is correctly positioned on the burner head.
It must be steady.
- The exact position of the pan support is
established by the rounded corners, which
should be set towards the side edge of the
hob.
- Do not force the taps if they are difficult to
open or close. Contact the technical
assistance service for repairs.
- Don't use steam jets for the equipment
cleaning.
FIG. 6
5
Advertisement
Table of Contents
