Ringtone Selection; Setting Ringtone Volume - Emos P5750.2T Manual

3. The chime LED will light up; release the
to self-learning pairing mode which lasts for 25 seconds. During this
time, press the ring button. The chime will ring and the button is now
paired with the chime. This automatically ends self-learning mode
(chime LED turns off).
4. To pair multiple buttons, repeat the process for each button from step 1.
Note: The chime has an internal memory where it stores the codes of the
currently paired buttons for the event of a power failure. There is thus no need
to pair buttons again after a power failure.
Erasing the Memory of Paired Buttons
Press and hold the pairing button
socket. The LED of the chime will light up after ca. 5 seconds. Release the
button. The LED will turn off. The memory of all paired buttons will be erased.

Ringtone Selection

1. Repeatedly press the
2. Each press of the button will play a different ringtone. The last ringtone
played is the one that will be used.
Setting Different Ringtones when Using Multiple Buttons
1. Plug the chime into a socket and long-press the pairing button
approximately 5 seconds.
2. The chime LED will light up. Release the
to self-learning pairing mode which lasts for 25 seconds.
3. Repeatedly press the ringtone change button
4. Each press of the button will play a different ringtone. The last ringtone
played is the one that will be used.
5. Press the ring button. The chime will ring.
Repeat this process for each paired button.

Setting Ringtone Volume

You can set 5 volume levels.
Repeatedly press the
(100 % – 75 % – 50 % – 25 % – 0 %). When set to 0 %, only the chime LED
will light up when the bell is rung.
Installing the Doorbell Button (Transmitter)
1. First, pair the button with the chime.
2. Before installation, check that the pair works reliably in the chosen spot.
3. Remove the rear cover by inserting a screwdriver into the hole on the
side of the button.
4. Use the double-sided adhesive tape (included) or two screws to fix the rear
portion of the cover to the wall. Although the button is weather-resistant,
choose a location where it is protected, e.g. in a wall recess.
on the chime. Plug the chime into a
or ringtone change button located on the chime.
button on the chime. Each press changes the volume
4
button. The chime will switch
button. The chime will switch
or on the chime.
for