Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Nexo P12-TIS
Summary of Contents for Nexo P12-TIS
- Page 1 DP3946-02-DI P12 / P12-TIS User manual...
-
Page 2: Table Of Contents
ARRAY EQ ____________________________________________________________________________ 12 MAINTENANCE ________________________________________________________________________ 13 TECHNICAL SPECIFICATIONS ___________________________________________________________ 15 USER NOTES _________________________________________________________________________ 16 EU Conformity declaration NEXO SA ZA DU PRE DE LA DAME JEANNE 60128 PLAILLY – France Declare under our sole responsibility that the product Loudspeaker... -
Page 3: Warnings
If the system seems to be malfunctioning or damaged, stop using it at once and have it repaired by a NEXO qualified technician. Do not expose the system directly to the sun or to the rain, do not immerse it into fluids, do not place objects filled with liquid on the system. -
Page 4: Equipment
EQUIPMENT EQUIPMENT 3 locations for rigging accessories, 1 at the back and one per side. WARNING: The depth of the M10 thread is 22mm (0.84 inch). On both sides, you’ll find a print for speaker stand. 3 locations for connecting, one at the back and one per side. Page 4 / 18... - Page 5 EQUIPMENT Assembly with pole stand or speaker stand Fix the pole stand on the connector plate (M20) of the Sub. Mount P12 on the pole stand / speaker stand (diameter of 35mm), IMPORTANT Speaker stand must be rated for P12 weight. Speaker stand must always be installed on a horizontal surface.
-
Page 6: Description
→ Amplification • The P12 speakers must be used with a NEXO processor to handle EQ, phase alignment, crossover and excursion/thermal protection for the system loudspeaker. There are two NEXO processor series supporting the P12 speakers: NXAMP (4 channels) amplified processors and DTD processors (stereo + sub). DTD processors ensure optimal performances when used with DTDAMP power amplifiers. -
Page 7: Preset
PRESET PRESET Please consult nexo-sa.com for NEXO TD Controllers firmware information. For the P12, the following setups are available: → MAIN is the recommended setup for most FOH application, similar to previous firmware setup. → MONITOR is recommended for monitor applications. Warning: this setup is a low latency setup and therefore its phase is not compatible with other NEXO cabinets, including subs. - Page 8 PRESET P12 + Sub Stage monitor applications with Subs (OMNI or CARDIO modes) Front of house applications with Subs (OMNI or CARDIO modes) Page 8 / 18...
-
Page 9: Hf Directivity
CROSSOVER FREQUENCY → 60 Hz: Full range application. → 85 Hz: Use as « front fill » on stage, complementing a main system. Use with a NEXO subwoofer, e.g. L15. → 120 Hz: Long throw application. Page 9 / 18... -
Page 10: Accessories
All P12 accessories are specifically rated in agreement with structural computations. Never use other accessories – including push-pins – when assembling P12 cabinets than the ones provided by NEXO: NEXO will decline responsibility over the entire P12 accessory range if any component is purchased from different supplier. - Page 11 ACCESSORIES PNT-WMADAPT With PNI-WMxxx & PNT-BUMP With PNT-BUMP PNI-P12TOL15 / PNI-P12TO2L15 P12 Under 1x L15 P12 under 2x L15 (Omni or Cardio) PNI-CLADAPT Ceiling Adapter, use with HBRK12, VBRK12. PNI-WM330 Wallmount for P12, with WMADAPT Page 11 / 18...
-
Page 12: Array Eq
ARRAY EQ PNT-P12FLGPS Flange dispersion adapter PS PNT-P12FLG9040 Flange dispersion adapter 90° - 40° PNT-2CASE12: FLIGHT CASE FOR 2X P12 PNT-ACC12: FLIGHT CASE FOR P12 ACCESSORIES PNT-COV12: COVER FOR P12 ARRAY EQ The ArrayEQ allows to adjust the system frequency response in its lower range (see curves below, with different ArrayEq values): Page 12 / 18... -
Page 13: Maintenance
MAINTENANCE MAINTENANCE Driver access Remove 8 screws. Unlock the 2 quarter-turn screws, Remove the grille. P12-TIS See above) Tightening torque: 3.5 Nm (Thread Locker: Loctite 242) Remove the 2 screws. Remove the stickers. Tightening torque: 2.5 Nm (Thread Locker: Loctite 222) To access to the HF diaphragm, remove 4 screws. - Page 14 Plastic Pad Black 05RUBGRD01-PW Plastic Pad White 05NHP12R/K HF diaphragm (with screws) 05HPC12 P12 driver complete (with screws) Recone Kit 1 ” (with screws) 05HPC12R/K NOTE: Speakers and Grills can be sent back to NEXO for recycling Page 14 / 18...
-
Page 15: Technical Specifications
Black or white structural paint P12: Magnelis® steel front grille + Back mesh Front finish P12-TIS: Black or white acoustic fabric fitted front Magnelis® steel grille Handle on both sides Threated inserts at the back and one on each side for connection of mounting... -
Page 16: User Notes
USER NOTES USER NOTES Page 16 / 18... - Page 17 USER NOTES Page 17 / 18...
- Page 18 Tel: +33 3 44 99 00 70 NEXO S.A. Fax: +33 3 44 99 00 30 E-mail: info@nexo.fr Parc d’activité de la Dame Jeanne nexo-sa.com F-60128 PLAILLY Page 18 / 18...