Table of Contents
Advertisement
■ Step 4) Connecting the door front/back
OA-607 T
1
Connect the pass through harness to the left end of
the door front OA-607 T and pass it through the 3/8"
(10 mm) hole.
Connect the pass through harness to the right end of
the door back OA-607 T.
Pass-through harness 8" (210 mm)
* I nsert the connector firmly to the base. If the insertion is
loose, a communication error with OA-607 T may result.
When a communication error is generated, the sensor
operation indicator will blink Orange twice.
■ Step 5) Setting the OA-607 T dipswitches
and adjustment of detection angle
Make the following settings for OA-607 T.
• Dipswitches (→ see "Settings".)
• Detection angle (→ see "Detection area adjustment".)
NOTE
Make sure that the detection angle is +5°.
If the detection angle needs to be changed, see "Detection
area adjustment".
■ Step 6) Fitting the cover on OA-607 T
1
Put the cover on from above and fit it in.
Pass the loop harness through the notch on the cover
side.
* Be careful not to disconnect the cable with the cover.
2
■ Step 7) OC-907C T and door controller I/O
wiring and OC-907C T power wiring
1
2
Notch
Install the remaining sensors similarly.
Connect I/O harness between the OC-907C T door
controller connector and the door controller.
For double doors, connect the other
I/O harness connector as well.
NOTE
With regard to the door controller connector, for single
swing door the door controller can be connected to either
the right/left sensor connector. For double swing doors,
the door controller installed on right/left doors can be con-
nected to either the right/left connector (note that right/left
must be aligned for the sensor connector).
WARNING
WARNING
Wire in accordance with the door controller specifications.
Connect harness wiring to the OC-907C T power
connector.
NOTE
The power connector is connected to 12 to 30 VDC with a
power harness.
9
Advertisement
Table of Contents
