Optex ELITE PRO Instruction Manual page 12

• Wiring example for single swing door
Power 12 to 30 VDC
Pink
Green
Yellow
White
* 4
Red
* 4
Red
Purple
Activation sensor
Push plate
* 1 : Do not wire for non monitored door.
* 2 : How to connect motor voltage signal. (Red wire)
* 3 : Connect the dry contact signal that is output when the door is fully closed.
* 4 : For stable sensor operation, connection to only one of BG input (recommended),
motor voltage input, or close switch input is recommended.
12
Polarity free for all wiring
Door controller
* 1
Test output
Stall input
Activation input
* 3
Electric strike
BG output
* 2
Motor
OR
Time delay module
Relay 1
output
OR
Knowing act
input
Relay 2
PUSH
delayed output
TO OPEN
Door controller
Red
Motor
Electric lock
Knowing act device
(e.g.,Push plate)