Optex ELITE PRO Instruction Manual page 8

For exposed wiring, use the jamb cover knockout.
Wrap the wiring in the longer corrugated tube included
as standard.
Knockout
4
Pass the loop harness taken out through the longer
corrugated tube included as standard.
5
Open and close the door and adjust the protruding
loop harness and corrugated tube length.
Loop harness
Cut the corrugated tube so that the door loop itself does
not enter the detection area, and at the same time put the
excess loop harness back into the jamb.
When the door loop is mounted on the swing side, make
sure that it will not contact the door panel while the door
is moving.
6
Pass the door loop cover through the corrugated tube
along with the loop harness.
Insert the corrugated tube along the guide of the loop
cover.
Wrap the loop harness around
the door loop cover.
NOTE
As in the figure above, wrap the loop harness around the
door loop cover to adjust its length.
8
Door loop cover
Wind the harness around
the door loop cover until it
matches the length here.
7
Fasten the door loop cover securely to the door leaf
with two Black mounting screws.
Black
× 2
8
Connect the loop harness to the side of OA-607 T.
Loop harness
* I nsert the connector firmly to the base. If the insertion is
loose, a communication error with OA-607 T may result.
When a communication error is generated, the sensor
operation indicator will blink Orange twice.
9
After adjusting the protruding loop harness and
corrugated tube length, prepare the jamb cover to be
mounted to the jamb.
Insert the corrugated tube along the guide of the loop cover.
10
Fasten the jamb cover securely to the jamb with two
Black mounting screws.
Black
× 2
Loop harness
Jamb cover