Table of Contents
Advertisement
Removing the cover.
Insert a flathead screwdriver into the right/left holes
on the cover bottom and push up to remove.
7
Remove the template.
8
With two of the four mounting screws included as
standard, mount the Silver mounting screws loosely.
Silver
× 2
Silver mounting screws for OA-607 T sensor head
9
After fixing OA-607 T to the door, tightly fasten the
Silver mounting screws.
10
Position OA-607 T on the other side of the door as
well.
■ Step 3) Installing the door loop (only on the
door loop mounting door side)
1
Apply the jamb cover template on the jamb.
Mounting template
for jamb cover
2
Drill two 1/8" (3.2 mm) mounting holes in the jamb for
the jamb cover (in accordance with the template).
For concealed wiring, drill an additional 3/8" (10 mm)
cable exit hole in the middle.
For exposed wiring, the 3/8" (10 mm) holes are not
necessary.
3
For general concealed wiring, bring the smaller loop
harness connector through from the jamb 3/8" (10 mm)
cable hole.
Loop harness
7
Advertisement
Table of Contents
