Table of Contents
Advertisement
Technical Information
1. Shut off the water supply.
2. Disconnect the WPS at the plumbing supply connection.
3. Remove the left side panel (5.1.1).
4. Remove the drip pan (5.1.2).
5. Disconnect the hose from the water.
6. Disconnect the electrical connection.
7. Unclip the wiring from the retainers. Release the WPS retainer from the rear of
the appliance and remove the WPS.
5.4.3
Flowmeter (circuit board) – Removal
Note
Only the circuit board on the flowmeter is the only part of the flowmeter
that can be replaced individually. In the event of mechanical failure within
the flowmeter the water inlet mixer must be replaced.
1. Remove the left side panel (5.1.1).
2. Release the circuit board retaining tab, and slide the board to remove it from the
water inlet mixer.
3. Disconnect the wiring.
5.4.4
Top Spray Arm Removal
1. Remove the cutlery tray if present.
2. Remove the top basket
3. Unscrew the screw connection and remove the spray arm.
5.4.5
Middle Spray Arm Removal
1. Remove the top basket.
2. Unscrew the screw connection and remove the spray arm.
G1000 / G2000 Dishwashers
84
Advertisement
Table of Contents
