Table of Contents
Advertisement
G1000 / G2000 Dishwashers
Starting with software version ID 984 the reactivation component test
operates as follows:
At the start of the mini-program the drain pump M8, water inlet valve Y2 and
EGS valve Y5 are activated at the same time. M8 pumps water for 30 sec.
and is primed with pulsed priming (2 sec. on/2 sec. off). Y2 and Y5 are
switched off when 250 ml has been reached or 60 sec. has elapsed. The
reactivation valve Y38 is then activated for 150 sec. following this, the water
inlet valve and the drain pump, which begins without pulsed priming (2 sec.
on/2 sec. off), are operated together for 60 sec.
Warning!
If the reactivation mini program has been started, it must not be cancelled
prematurely. If it is interrupted, there is a risk that brine will overflow out
of the SIT, salt container in door, into the machine cabinet.
V12.
Y60, Brine valve (salt container in door (SIT) valve):
The brine valve is activated for 60 sec.
V13.
Y38, reactivation valve:
The reactivation valve is activated for 60 sec.
V14.
M2, fan:
The fan is activated for 60 sec.
V15. B3/9, M6, circulation pump with Speed sensor
The circulation pump with switched auxiliary winding is activated for 30 sec.
at maximum speed. If the desired speed has not been reached within 7 sec.,
the circulation pump remains station
V16.
4N1, M6, wash sequence with middle spray arm sensor (miniprogram):
This starts with 30 sec. drainage, which begins with pulsed priming (2 sec. on
/ 2 sec. off). The water inlet valve is then activated (on models with and
without slide shutter) until 5.4 l has been taken in. Concurrently with water
inlet valve activation, the slide shutter is set to
position. The circulation pump with switched auxiliary winding is then
operated. If a spray arm fault is registered during circulation pump operation,
the pump is switched off after 60 sec., otherwise if operates for an additional
120 sec.
191
Technical Information
the middle spray arm
Advertisement
Table of Contents
