Inspira Series - G1180 & G2180; G1180 / G2180 - Programming Mode - Miele G2000 Technical Information

G1000 / G2000 Dishwashers
6.3.2 Inspira Series - G1180 & G2180
6.3.2.1

G1180 / G2180 - Programming Mode

Initial requirements
3. Open the door.
4. Switch off the machine.
Accessing
1. Press and hold the program button.
2. Switch on the machine.
3. Release the program button.
4. Immediately press and release the program button 5 times and at the 5th time
hold until the Rinse & Hold LED flashes rapidly.
5. Release the program button
If the Rinse & Hold LED has not started to flash within approx. 4 sec., the accessing
procedure must be repeated.
Acknowledgement indicator
Successful accessing of the Service Dept. programming mode is indicated by a rapid
flashing Rinse & Hold LED (5 Hz)
Options
Refer to Tables: 6-23 through 6-28.
Note
Upon accessing the programming mode, to navigate between the various
functions and making changes within them you must do the following:
1.To navigate the Functions insure the Intake/Drain Lt. is solid. If not,
hold the Program button until the Intake/Drain Lt. becomes a solid
light. Now the Program button can be used to navigate the Functions
bar.
2.To make setting changes within each Function, hold the Program
button until you see a blinking light from the Intake/Drain Lt. Now you
can use the Program button to make your setting changes within each
Function. The Sani-Wash Lt. will indicate what the setting is for each
Function.
139
Technical Information