Figure 1. Installing The Barrel Standoff; Figure 2. Installing The Intel ® Integrated Raid Module Rms2Mh080 - Intel RMS2MH080 Hardware User's Manual

4. Attach the Intel
matching server/workstation board connector, and press the module card firmly to
engage the barrel standoffs installed in step 3 (see
5. Press down gently but firmly to ensure that the card is properly seated in the
connectors, and then insert the three pin standoffs into the barrel standoffs
respectively ( see
Figure 2. Installing the Intel
6. Connect the SAS/SATA cables from the backplane (or hard drives) to the RAID
module (see
Right-angle end or Vertical end of the SAS/SATA cable to the SAS connectors of
the controller, see your server/workstation board or chassis documentation. Make
sure the cables are properly connected to the controller.
Note: System throughput problems can occur if non-standard SAS cables are used.
8

Figure 1. Installing the Barrel Standoff

®
Integrated RAID Module RMS2MH080 module card to the
Figure 2).
Figure 3). For information regarding connecting the recommended
To minimize the potential for problems:
Figure
®
Integrated RAID Module RMS2MH080
Intel® Integrated RAID Module RMS2MH080 Hardware User's Guide
AF003481
2).
AF003482