Page 1
Intel® RAID Maintenance Free Backup Unit 4 Quick Installation User's Guide Thank you for buying an Intel® RAID Maintenance Free Backup Unit 4. The Intel® RAID Maintenance Free Backup Unit 4 supports the Intel® RAID Controller RS3DC040 and RS3DC080. The following information will help you assemble your Intel ® RAID Maintenance Free Backup Unit 4 and install components.
Prepare the Host Computer ................... 2 Remove the RAID Controller from the Computer ..........2 Attach the RMFBU4 Module to the RAID Controller ......... 2 Install the Clip on the Remote Mount Board ............3 Attach the Super Capacitor Pack Module to the Clip ........3 Connect the RMFBU4 Module to the Remote Super Capacitor Pack Module (Valid for Remote Mount Board) ..............
Intel ® Server Chassis. The following figure shows the front view and the back view of the RMFBU4 module. The front view is the side that you can see when the unit is installed on a RAID controller. Connector...
Center the screwdriver carefully to avoid stripping the screw heads. Do not over-tighten the screws. Hold the RMFBU4 module so that the front side faces upward, and align the J2 connector on the RMFBU4 module with the connector on the RAID controller.
General Installation Process Install the Clip on the Remote Mount Attach the Super Capacitor Pack Board Module to the Clip Ground yourself, and make sure that the system is grounded. Ground yourself, and make sure that the system is grounded. Place the clip and the remote mount board module front-side-up on Place the Super Capacitor Pack module and the clip front-side-up a flat, clean, static-free surface.
Insert one 9-pin cable connector on the cable into the 9-pin J1 NOTE: This RAID controller is a PCIe x8 card, and it can connector on the RMFBU4 module, as shown in the following operate in x8 or x16 slots. Some PCIe slots, however, support figure (the cable is blue).
Locate the mounting holes for the Super Capacitor Pack module clip in the Intel ® Server Chassis. Align the tabs on the clip with the mounting holes in the Intel ® Remote Mount Board Server Chassis and slide the clip until the clip engages with the mounting holes.
Insert one 9-pin cable connector on the cable into the 9-pin J1 NOTE: This RAID controller is a PCIe x8 card, and it can connector on the RMFBU4 module, as shown in the following operate in x8 or x16 slots. Some PCIe slots, however, support figure (the cable is blue).
Reference Documents If you need more information about any topic covered in this guide, refer to the following documentation on the Intel website at http://www.intel.com/support: • ® Intel RAID Controller RS3DC040/RS3DC080 Quick Installation User's Guide • 12Gb/s Intel ® RAID Controllers User Guide •...