Table of Contents
Advertisement
General Installation Process
1
Unpack the RAID Module
CAUTION: It is good practice to back up your data before
adding hardware, such as a RAID module, to your system.
Unpack the RAID module in a static-free environment. Remove the
module from the antistatic bag, and inspect it for damage. A low-profile
bracket is included with the RAID module. If the RAID module appears
to be damaged or the low-profile bracket is missing, contact Intel or
your reseller support representative.
The latest versions of the documentation, drivers, and firmware are
available on the Intel website at http://www.intel.com/support. See
Reference Documents
for more information.
The website contains utility programs, device drivers for various
operating systems, and related documentation.
3
Install the Barrel Standoff
A
Power down the system and disconnect the power cord.
B
Locate the matching SAS Module connector on your server board.
See your server board documentation.
C
Insert the barrel standoffs into the matching holes in the server
board. The Intel
®
Server Board S2600GZ is shown for illustrative
purpose.
2
Prepare the Host Computer
CAUTION: Before you install the RAID module,
make sure that the host computer is disconnected
from the power and from any networks.
Turn off the host computer, and unplug the power cords
from the rear of the power supply. Remove the cover from
the host computer.
4
Install the RAID Module
A
Attach the RAID Module to the matching server board connector
and press the module card firmly to engage the barrel standoffs.
B
Press down gently but firmly to ensure that the card is properly
seated in the connectors, and then insert the four pin standoffs into
the barrel standoffs respectively.
2
AF006533
Advertisement
Table of Contents
