Overriding The Default Display Mode - Planar Dome M2/PCI Installation Manual

56 | Solaris Driver

Overriding the default display mode

To start CDE or OpenWindows using the default display
mode, skip this section.
You can override the default display mode by editing the
OWconfig
resolution. (See the table on page 79 in Appendix A for the
DIP switch settings.)
Edit the
and customize your configuration for OpenWindows or CDE.
This file exists in
/etc/openwin/server/etc
Edit the one in the
To edit the OWconfig file
When you install a new driver, it overwrites the
file in the
OWconfig file in the
remains unchanged. This ensures that the changes you make
will not be overwritten when you update to newer versions
of the DOME driver. Make sure you edit these lines in the
/etc
directories, your system ignores them.
1
file or by setting DIP switch S1 to your preferred
file to override the default display mode
OWconfig
/usr/openwin/server/etc
/etc/openwin/server/etc
/usr/openwin/server/etc
directory only. If you uncomment these lines in both
Find the following lines in the
#class="XSCREENCONFIG" name="DOMEm2pci0Config"
# device="/dev/m2pci0.0"
# res="1600x1200 @ 73Hz"
# stereo="1024x1024 @ 121Hz"
# monitor="domegray.vda"
# board="m2pci-2hd.xqa";
#class="XSCREENCONFIG" name="DOMEm2pci1Config"
# device="/dev/m2pci0.1"
# res="1280 x 1024 @ 76Hz"
# monitor="domecolr.vda"
# board="m2pci-2hd.xqa";
directory on the workstation.
/etc/openwin/server/etc
OWconfig
and in the
directory.
OWconfig
directory. The
directory
file.