Motorola R-2550 Programming Reference Manual page 70

EF
Description:
Command Syntax:
Parameters:
Notes:
RF-Control
Monitor/Narrow-Band
Monitor/Wide-Band
Generate/AM
Generate/FM/Narrow-Band
Generate/FM/Narrow-Band
Generate/PM/Wide-Band
Generate/PM/Wide-Band
Motorola Communications Analyzer
Programming Reference
The EF command sets the DPL Encode modulation source switch and specifies its
modulation level. If the synthesizer is not selected to DPL, the Invalid Mode Error (09)
is generated.
EF nl ,n2
Description: DPL Encode Modulation Switch
optional: Yes
<Decimal Numeric Program Data>
Type:
units: None
Resolution:
Range: 0: Continuous
1: off
Start Disconnect tone
3: Stop Disconnect tone
Reset: 1
Description: DPL Encode Modulation Level
optional: Yes
Type:
units:
Mode dependent, see notes
Resolution:
Mode dependent, see notes
Range:
Mode dependent, see notes
Reset:
Modulation Level based upon the RF-Control mode of the analyzer.
Mode Units
V
V
%
rad
rad
DPL Encode Modulation Switch
Resolution
Range
0.000
0.005 v
0.05 v
0
1 %
0.05 kHz
0.05 kHz
0.01 rad 0.50 - 2.00
0.1 rad 2.0 - 10.0
and
Level