Table of Contents
Advertisement
MTW
Notes:
The
command will cause the Avg Wataneter to perform differently than it does
when it is used under local control. The MTW command will start the meter. It will
stop after one measurement is completed. The user will be required to resend the MTW
command to start another measurement. In addition, the user is required to wait until
the measurement is complete before issuing a query. Due to the intensive processing
demands of the Average Wattmeter, any query issued before the measurement is
complete will not be answered, and a transmission error may result for the next
command which is attempted. The M?, ?, or *TRG queries will return the given
response following the issuance of the MTW command. The response will only be
returned in the monitor or duplex modes.
25
Motorola Communications Analyzer
(continued)
Advertisement
Table of Contents
