Table of Contents
Advertisement
BL
Description:
Command Syntax:
Parameters:
Notes:
Motorola Communications Analyzer
Cellular Option Programming Reference
BL command sets the Cellular Encode modulation source switch and specifies the
The
modulation level of the SAT Encode source. If the
Invalid Mode Error (Error 09) is generated.
BL nls2
Cellular Modulation Switch
optional:
Yes
Type:
units:
None
Resolution:
Range:
0: Continuous
1: off
Description:
SAT Modulation Level
optional:
Yes
Type:
<Decimal Numeric Program Data>
units:
Mode dependent, see notes
Resolution:
Mode dependent, see notes
Range:
Mode dependent, see notes
Reset:
0.000 v
The value of n2 sets the modulation level for SAT, but has no effect on DSAT and DST
modulation levels. The following table describes the Units, Resolution, and Range
values for the Modulation Level based upon the RF-Control mode of the R-2600.
RF-Control Mode
Monitor/Narrow-Band
Monitor/Wide-Band
Generate/FM/Narrow-Band
The BL command is not available
on the R-2550.
Cellular Encode Switch and Level
synthesizer source is not SAT, the
Resolution
Range
0.005 v
0.000 - 0.795
0.05 v
0.00 - 7.95
1%
o-99
0.05 kHz
0.00 - 9.95
0.5 kH2
0.0 - 99.5
Advertisement
Table of Contents
