Install The Ax1 Display Controller - Planar Dome Q2 Reference Manual

QUICK LINKS
Contents
Index
Regulatory Compliance
Product Information
Warranty
GETTING STARTED
About the Q2 Display
Check Package Contents
Identify Components
Position the Display
Desk Stand Features
INSTALLING THE DISPLAY
Install AX1 Controller
Connect Cables
Install Display Driver
Adjust Display Properties
OPERATING THE DISPLAY
Front-Panel Controls
Screen Adjustments
Dome CXtra Software
APPENDIXES
Troubleshooting
Specifications
USB Connections
Power Management System
Driver Removal

Install the AX1 Display Controller

Remove any existing graphics card and its driver from your computer system
before you install the AX1 controller and driver. Also disable any onboard
graphics capability on the motherboard. See safety precautions to the right.
To install the controller
1 Turn off your computer and all peripherals. Disconnect all cables from
your computer. Leave the power cord plugged in for grounding.
2 Remove the computer cover, then remove any existing graphics card and
video signal cable, if necessary.
3 Remove the blank bracket from the PCI Express slot. (See left photo, below.)
4 Insert the AX1 controller into the slot, align the connector pins, and
press the board down until it is firmly seated. (See right photo, below.)
5 Secure the mounting bracket, and reattach the cover and the peripherals.
Remove blank bracket for PCI Express slot
Dome Q2 Display
Install AX1 controller
Warning
If you are disconnecting a peripheral
or removing a component from the
system board, wait 10 to 20 seconds
after you turn off the computer.
Make sure the standby power LED
has gone out.
If you leave the computer on, you
could get an electric shock and cause
damage to system components.
Remove the AX1 display controller
slowly from its package and static-
shielding bag to prevent an
electrostatic discharge.
Static electricity can damage the
controller. When touching the board
or parts of the motherboard, take
these precautions:
•
Wear an antistatic wrist strap.
•
Discharge your body's static
electricity repeatedly by touching
the power supply or the metal
surface of the computer chassis.
8