NOTE: This is for micro-adjustment only. If fence cannot be adjusted square, recheck rail adjustment.
•
Lock fence in position and recheck. Continue this procedure until fence is square to the table.
PARALLEL ADJUSTMENT
•
Position fence so that fence edge is aligned with slot edge.
•
Slot and fence edge should be parallel.
•
If an adjustment is necessary, unlock the fence and turn either of the two adjusting screws.
•
Lock fence in position and recheck. Continue this procedure until fence is square to the table.
CURSOR ADJUSTMENT
Refer to following fi gure.
•
Raise the saw blade above the table.
•
Position the fence several inches to the right of the saw blade.
•
Lock the fence down and measure the exact distance between the saw blade and the inside of the fence.
•
Loosen the two screws on the lens and slide it left or right until the cursor (red line) equals the measurement
obtained in the previous step.
•
Retighten the screws and make a test cut. Measure the cut piece to verify that the cursor is set correctly.
NOTE: This adjustment should be checked whenever a new blade is installed.
31
5 Operating Procedures