Page 1
MK.300.I MITER SAW 10″ WITH LASER GUIDE AND DUAL SLIDING RAIL ___________________________________________________________________ INSTRUCTION MANUAL ___________________________________________________________________ ATTENTION: READ THIS MANUAL BEFORE USING THE PRODUCT.
Page 3
Do not use the saw in hazardous environments. Do INSTRUCTION MANUAL not use power tools in damp or wet or exposed to rain. Important information you should know: Keep the work area well lit. Make cuts only with sharp blades. Discs that are not sharp do not cut properly and overload the engine.
Page 4
Never step on the tool. A serious accident can occur Protect the power supply line with at least a 15 amp if the tool is tilted or if the tool is touched accidentally. fuse or a circuit breaker. Check for damaged parts. Before continuing to use Make sure that the blade is turning in the correct the tool, a guard or other part that is damaged must be direction and that the teeth at the bottom of the blade...
Do not operate the saw without the guides. on the plate. A 10% decrease in voltage or more will cause loss of power and overheating. All MAKSIWA Do not perform any hands-free operation. equipment is tested at the factory. If this tool does not Do not reach around or behind the blade.
Page 6
Dispose the packaging in a sustainable lock the shaft with one hand and use the blade wrench environmental way. with the other to loosen (clockwise) the screw in the slot on the left side of the blade. The miter saw is designed to operate indoors and NEVER TIGHTEN THE AXLE LOCK PIN WHILE THE must be placed on a firm, stable and level surface, as explained below:...
Switch: handling or any other reason, follow the steps below to adjust your saw. Once these adjustments are Turn on the saw, press the trigger switch. To turn the made, they will remain accurate. Follow these tool off, release the switch. There is no mechanism to lock the switch in the on position.
Page 8
0º and 45º to the right or left. falling. Cut Quality CHECK THE MAKSIWA CATALOG AND FIND The smoothness of any cut depends on a number of PRODUCTS FOR THIS FUNCTION. Cutting Frames, variables. Factors such as the type of material being...
2. 2. The miter plans at the rear of the frame must fit Examples Number of sides Chamfer or Square angle directly on the guide and the saw table. 45º 3. 3. Check the cuts so that they are flat, thus 36º...
(including inspection and particularly when making angular cuts. replacement) to the technical assistance recommended by MAKSIWA, which will always use genuine spare parts and accessories, reassembling your saw in the same way as the original. MAINTENANCE The use of this tool for professional or industrial 1.
Need help?
Do you have a question about the MK.300.I and is the answer not in the manual?
Questions and answers