Table of Contents
Advertisement
CHECK AND ADJUST THE LASER
The laser is an optional accessory. If your machine has not this part, skip this step.
•
Turn on the switch, check if the laser line is in the middle of the blade and blade mark. If not, some adjustments
are needed.(The blade mark should have been aligned with blade)
•
To adjust the laser line:
•
Loosen the two set screw.
•
Move and rotate the laser generator to adjust the laser line, make it is in the middle of the blade and blade
mark. Retighten the two set screw.
BLADE GUARD AND RIP FENCE STORAGE BRACKETS
Refer to following fi gure.
•
Install the blade guard storage brackets to the left stand using four M4X8 pan head screws and fl at washers.
•
Install the rip fence storage brackets to right stand using two M6X20 socket head bolts.
25
4 Unpacking and Checking Contents
Advertisement
Table of Contents
