ATTACH SWITCH ASSEMBLY
Refer to following fi gure.
•
Remove the cover from left front rail, Insert bolt heads into T-slot on bottom of left front rail. Replace the
cover.
•
Slide switch assembly 6"to 8"from left end of rail.
•
Fully tighten fl at washers, lock washers and hex nuts to secure switch assembly in place.
POSITION AND ADJUST RIVING KNIFE
Refer to following fi gure.
•
Unlock and remove the table insert.
•
Lift up the locking lever and install the riving knife .
•
Make sure the pin is aligned with riving knife hole and press down the locking lever to secure riving knife in
position. Replace the table insert.
•
Riving knife must be in line with blade.
22
4 Unpacking and Checking Contents