Table of Contents
Advertisement
INSTALL BLADE
Refer to following fi gure
•
Unlock the knob and remove the table insert.
•
Raise blade assembly all the way up.
•
Pull arbor lock and use wrench to loosen fl ange nut. Remove fl ange and nut from arbor.
•
Place blade on arbor. Make sure arrow on blade and teeth point towards front of saw.
•
Replace fl ange and nut on arbor and securely snug blade in position. Replace the table insert.
CHECK TABLE ALIGNMENT
Refer to following fi gure.
•
Saws are shipped from the factory with the table adjusted so the miter gauge slots are parallel to the saw
blade. However, in order to obtain the best results from the saw, it is suggested this adjustment be checked
before operating.
•
A simple method of checking alignment is as follows: Bolt or clamp a dowel rod or similar object to miter
gauge (a combination square can be substituted). Pick out a tooth on front of blade and set the dowel to it
so it is just touching. Move same tooth to back of blade.
20
4 Unpacking and Checking Contents
Advertisement
Table of Contents
