Maintenance Work - Weber mt CR 5 Operating And Maintenance Manual

Maintenance work

Changing the engine oil
Open the cover lid (1) of the oil filler neck.
Only drain engine oil when at operating temperature.
Screw the oil drain pipe (1) onto the engine drain valve and
drain off the oil.
After emptying completely, unscrew the oil drain pipe
from the drain valve and fill with oil in accordance with the
specification.
When working in the area of the engine compartment
there is danger of burn injury!
Danger of scalding due to hot oil.
Cleaning the engine oil filter
Drain engine oil.
Loosen the screw (1) approximately 5 revolutions.
Danger of scalding due to hot oil.
Pull the oil filter (1) out of the motor compartment.
Blow out the oil filter (1) from inside to outside with
compressed air.
Lightly oil the sealing rings (2) on both sides of the oil filter.
Check sealing rings (2) for damage and firm seat, replace
the oil filter if there is damage.
Press the oil filter into the crankcase until the stop.
Only drain engine oil when at operating temperature.
Prior to tightening the screws ensure that the tension
springs rest on the oil filter with both ends „1".
16
1
1
1
CR5