Table of contents Introduction General safety guidelines Graphic presentation Technical data Transport Activities prior to starting work Electrical connection Connecting the interior concrete vibrator to the converter Initial operation Shutdown Maintenance Troubleshooting Circuit diagram Contact addresses IVURplus D...
Introduction This operating and maintenance manual is designed to facilitate familiarization with your interior concrete vibrator, and enable you to maintain the interior concrete vibrator and use it in accordance with the proper application possibilities. When complying with the instructions in the operating and maintenance manual you help avoid hazards, reduce repair and downtime costs, and increase the reliability and service life of your interior concrete vibrator.
Safety and operating instructions General All safety instructions must be read and complied with, non-compliance results in – danger to life and limb of the user – impairments to the machine or other property. In addition to the operating manual, the accident-prevention regulations in the country where the appliance is used must be complied with.
Page 6
Electrical voltage safety It is prohibited to switch the interior concrete vibrator on or off by removing or inserting the connector plug into or from the power outlet. The connecting cable of the interior concrete vibrator must not be used to pull the plug out of the power outlet.
Page 7
Operation Prior to starting work the owner of the interior concrete vibrator must be familiar with the work environment. The working environment includes obstacles in the work and traffic area, the bearing capacity of the ground, as well as the necessary safeguarding of the construction site. The interior concrete vibrator should only be operated when the protective fixtures are mounted.
Page 8
Inspection German social accident insurance (DGUV) regulations mandate that DGUV directive 3 be applied during the testing of electrical installations and equipment. Owing to the specific type of protective device, which corresponds to a PRSD-S, the insulation resistance of < 1 M Ohm (0.25) applies. Interior concrete vibrators must be inspected in accordance with appropriate implementation conditions and operating conditions, as needed;...
Transport When transported on vehicles, the interior concrete vibrator must be secured against slipping or rolling away using suitable means. Activities prior to starting work electrical connection Before putting the interior concrete vibrator into operation, make sure the mains voltage (1) corre- sponds to the voltage specified on the rating plate.
Initial operation Connect the interior concrete vibrator only to a voltage supply that corresponds to the voltage specified on the rating plate. Always insert the power plug into the power outlet before switching on the converter. Insert the power plug (1). Put the converter into operation by pressing the switch (1).
Maintenance Maintenance Maintenance Maintenance interval point activity Daily Entire machine – Clean unit – Check connecting cable and plug for exterior damage Every 200 – Check bottle neck and operating hours bottle tube for wear, replace if necessary Work must be carried out using regulation tools, and the operating and maintenance manual must be complied with for all work.
Page 15
Blink code at converter The switch housing may only be opened by skilled personnel. The converter board is live after the removal of the switch housing. – Danger to life – Cover (1) Housing (2) Electronics (3) LED yellow (4) LED display Cause Operating status...