Installing The Top Cover - Danfoss iC7 Series Installation Manual

In-bottom/Out-back Cooling Kit for FA09-FA10
Installation Guide
8x Ø 7 (0.3)
Illustration 6: FA10 Cabinet Backplate Template for In-bottom/Out-back Cooling

2.5 Installing the Top Cover

To install the top cover of the cooling kit, use the following steps. See
Procedure
1.
Remove the paper backing from the top cover gasket to expose the adhesive.
2. Adhere the top cover gasket to the underside of the top cover.
3.
Remove 8 M5x14 screws (T25) surrounding the sides and back of the vent in the top of the frequency converter. Retain the
screws.
4. Remove 3 M5x12 screws (T25) at the front of the vent in the top surface of the frequency converter.
5. Slide the edge of the top cover under the 3 loosened screws, positioning the cover over the vent in the top of the frequen-
cy converter.
6.
Secure the top cover to the frequency converter with the M5x14 screws (T25) removed previously in step 3.
Torque all screws to 2.3 Nm (20 in-lb).
Danfoss A/S © 2022.03
352 (13.8)
11 (0.4)
12 (0.5)
163 (6.4) 188 (7.4)
Illustration 7.
AN371942757356en-000101 / 136R0252 | 9
Installation