Danfoss iC7 Series Installation Manual page 5

In-bottom/Out-back Cooling Kit for FA09-FA10
Installation Guide
1 Mounting plate
2 Top cover
3 Top cover gasket
4 Frequency converter
5 Duct support plate gasket
6 Duct support plate
2.3 Preparing the Mounting Plate
To create mounting holes and vent holes in the mounting plate, use the following steps. Use the dimensions in
FA09 frequency converters, and
Procedure
1. Drill 4 mounting holes in the mounting plate using the dimensions in the template.
The holes must match the holes in the frequency converter.
2. Insert 4 M10 pem nuts (not supplied) in the mounting holes.
3.
Cut out the vent opening in the mounting plate using the dimensions in the template.
The openings must match the upper duct opening in the frequency converter.
Danfoss A/S © 2022.03
Illustration 4 for FA10 frequency converters.
7 Telescopic bottom duct
8 Upper mounting hole
9 Mounting plate gasket
10 Back vent
11 Backplate
12 Lower mounting hole
AN371942757356en-000101 / 136R0252 | 5
Installation
Illustration 3 for